A plumbing trade that keeps your schedule intact

1. 1

   Drawing review

   We review the plan set and flag venting, clearance, drain slope and capacity problems before anything is opened up.

2. 2

   Scope by phase

   Priced by rough-in, set and final so it maps to your draw schedule rather than a single lump number.

3. 3

   Rough-in on your sequence

   We commit to a slot in your schedule and tell you promptly if anything on site changes what is possible.

4. 4

   Set, final and walk

   Fixtures set, water heater commissioned, and a walk with you before you call it done.

Documentation you can expect

• Phase-based scope tied to rough-in, set and final
• Written notes on any plan conflicts found and how they were resolved
• Equipment model, serial and capacity for the closeout package
• Invoices structured by phase for your draw schedule
• Warranty paperwork for installed equipment handed to you at closeout

Licensing, bonding, insurance certificates and warranty terms are provided on request and vary by jurisdiction. Nothing on this page should be read as a guaranteed response time or a certification we have not documented for you.

• Reusing an existing heater in a renovation only makes sense if its age and capacity fit the finished fixture count — we will run that math with you.
• Adding a bathroom usually pushes an older 40-gallon tank past its practical limit; sizing it correctly now avoids a callback from your client later.
• Where a relocated heater cannot be vented compliantly in the new position, we will say so during drawing review, not during rough-in.
• Partial repipes of the affected branch are often better value than replacing sound piping outside the scope.

Have this ready when you call

• The plan set, including mechanical and fixture schedules
• Project address, jurisdiction and permit status
• Your schedule with rough-in and inspection dates
• Fixture selections, especially anything high-flow
• Existing water heater type, fuel, size and location